By using separate coils we improve the cooling and heating capacity of the total system. The Perfect Fit™ 1963 Galaxie air conditioning system is engineered to fit a 1963 Galaxie It comes equipped with carefully sized, large, separate A/C and Heat coils just like factory (OE) systems, not combined A/C, Heat coils often found on aftermarket systems. Our RETROFIT designs give OE quality combined with better than original performance and reliability. Every component was chosen for its superior design and quality rather than a low cost. Not Just Aftermarket Air Conditioning!Ĭlassic Auto Air’s Perfect Fit™ model specific systems are not your typical, one-size-fits-all, low-quality, aftermarket air conditioning system. Each kit comes with detailed, easy-to-follow installation instructions and mounting templates when needed. The Perfect Fit™ 1963 Galaxie air conditioning system is designed specifically to bolt into your 1963 Galaxie with minimum modification to your vehicle. This will allow infinite adjustability over all modes, providing you with powerful air conditioning, heat on the floor, and dehumidified defrost. Our system is engineered specifically to use the original 1963 Galaxie heater controls by providing you all new blower switch, brackets, cables and wiring to make your controls work like new. This model specific Perfect Fit™ system allows you to retrofit an original, standard, 1963 Galaxie with full air-conditioning. in the USA.Model Specific Perfect Fit™ A/C, Heat and Defrost. The evaporator unit is manufactured by Nostalgic Air Parts, Inc. A radiator fan or a condenser fan may be needed depending on your current setup. This is a complete a/c system that will include all the parts necessary to add a/c except the refrigerant to charge it.
If you have a 289 engine the comrpessor bracket will mount on top of the engine, driver side. The second compressor pulley will route around the alternator, this setup eliminates any needs for more pulleys.
One pulley on the clutch will run on the stock pulleys on the engine. The compressor will have a double groove clutch pulley. The compressor mounts on the lower passenger side of the engine. The compressor mount bracket will require an alternator. If your Falcon has a six cylinder motor it will not require any extra pulleys. We will include the correct bracket for your engine, select from the drop down menu above. The evaporator unit is designed to fit under the dash without interferring with the foot space of the driver or passenger. Please provide us with the year and engine information in the space below.Ĭomplete a/c kit for a Ford Falcon with a six cylinder or a V-8 engine. For Chevy Small Block and Big Block Engines, you will also need a 2 Groove Water Pump Pulley (If using V-Belts). All kits will require a 3 Groove Crank Pulley (If using V-Belts). The system uses R-134a refrigerant.Īll of our complete kits come with everything needed to install Air Conditioning in your vehicle except for Pulleys (sold separately). If you have a 289 engine the Compressor bracket will mount on top of the engine, driver side. The evaporator unit is designed to fit under the dash without interfering with the foot space of the driver or passenger. Complete a/c kit for a Ford Falcon with a six cylinder or a V-8 engine.